RV750ULHW serves as an automotive or stationary DC-to-AC inverter with automatic line-to-battery transfer and integrated battery charger Supports 120V AC output from a 120V AC line power source or 12V DC battery source 16.6 millisecond automatic transfer between line and battery power supports UPS protection during blackouts and voltage fluctuations for equipment compatible with a one cycle transfer time 750 watts continuous AC output in inverter mode

750 watts continuous AC output in AC mode Double Boost inverter output supports momentary startup loads up to 200% of the continuous rating for up to 10 seconds OverPower inverter output supports longer duration overloads to 150% for 1-60 minutes under ideal battery and temperature conditions. (For best results

utilize OverPower usage for as short of a duration as possible

ensure battery bank and cabling is able to provide full nominal DC voltage under load and allow inverter/charger to fully cool before and after OverPower usage.) 3 stage

selectable 11/45 amp battery charger with adjustable settings for wet/gel battery types offers fast

reliable battery recharging Protected hardwire bolt-down input lugs safely accept heavy gauge input wiring from attached battery bank Protected hardwire output passes 120V line power or inverter output through to connected equipment Reliability enhanced large-transformer design tested to UL (USA) and CSA (Canada) standards Moisture-resistant construction enables vehicular or marine operation in high humidity environments 3 position operating mode switch supports "AUTO" mode to enable automatic transfer between DC and AC modes

CHARGE-ONLY to maintain a full battery charge when AC is present without auto transfer and SYSTEM OFF settings Set of six front panel LEDs display AC/DC operational modes

overload status

DC voltage level

shutdown status and system fault status

SmartPro line-interactive UPS system is ideal for voice

data

medical and industrial networking applications Line-interactive voltage regulation maintains selectable 100V

110V

or 120V nominal output during brownouts as low as 85V and overvoltages to 145V Enables continuous operation through blackouts

voltage fluctuations and surges Line-interactive automatic voltage regulation (AVR) provides 14% voltage boost during brownouts and a 12% voltage cut during overvoltages Standard internal battery set offers 20 minutes runtime at half load (450 Watts) and 8 minutes at full load (900 Watts) Space-saving upright tower format Network interfaces support simultaneous communications via built-in USB port

DB9 serial port and SNMPWEBCARD slot HID-compliant USB interface enables integration with built-in power management and auto shutdown features of Windows and Mac OS X. Included PowerAlert UPS monitoring software supports safe unattended shutdown

monitoring and control via local connected servers

plus any number of additional servers over IP UPS interface supports on-battery

low-battery

power-restored

AC-voltage

DC-voltage

output current monitoring

battery charge current

battery capacity

timed inverter sutoff

activate self-test and output power control NEMA 5-15P input plug

8 x NEMA 5-15R output receptacles Front panel LEDs offer current monitoring

voltage regulation and battery charge level information UPS ships fully assembled in full compliance with DOT regulations

no time-consuming connection of internal batteries by user required Single-line tel/DSL or network Ethernet line surge suppression